INDUSTRY REGULATED - LOGGERS INDUSTRY REGULATED - MINERS OSHA 1910.266, Says the Following About First Aid Kits in the Logging Industry: ✓ The employer shall provide first-aid kits at each work site where trees are being cut (e.g., felling, buckling, limbing), at each active landing, and on each employee transport vehicle. The number of FirstAid kits and the content of each kit shall reflect the degree of isolation, the number of employees, and the hazards reasonably anticipated at the work site. ✓ At a minimum, each first-aid kit shall contain the items listed in Appendix A at all times. ✓ The employer also may have the number and content of first-aid kits reviewed and approved annually by a health care provider. ✓ The employer shall maintain the contents of each first-aid kit in a serviceable condition. OSHA 1910.266-Appendix A, Lists the Minimum Supplies Required: The following list sets forth the minimally acceptable number and type of first-aid supplies for firstaid kits required under paragraph (d)(2) of the logging standard. The contents of the first-aid kit listed should be adequate for small work sites, consisting of approximately two to three employees. When larger operations or multiple operations are being conducted at the same location, additional first-aid kits should be provided at the work site or additional quantities of supplies should be included in the first-aid kits: MSHA 30 CFR § 75.1713 Emergency medical assistance; first-aid. Each coal mine shall have an adequate supply of first-aid equipment located on the surface, at the bottom of shafts and slopes and at other strategic locations near the working faces. In fulfilling each of the requirements of this section, the operator shall meet at least minimum requirements prescribed by the Secretary of Health and Human Services. MSHA 30 CFR §75.1713-7 First-aid equipment; location; minimum requirements. Each operator of an underground coal mine shall maintain a supply of the first-aid equipment set forth in paragraph (b) of this §75.1713-7 at each of the following locations: ✓ At the mine dispatcher’s office or other appropriate work area on the surface in close proximity to the mine entry; ✓ At the bottom of each regularly traveled slope or shaft; however, where the bottom of such slope or shaft is not more than 1,000 feet from the surface, such first-aid supplies may be maintained on the surface at the entrance to the mine; and ✓ At a point in each working section not more than 500 feet out by the active working face or faces. The first-aid equipment required to be maintained under the provisions of paragraph (a) of this §75.1713-7 shall include at least the following: 1. *One stretcher; 6. Twelve 1-inch adhesive compresses; 2. *One broken-back board. 7. One foille; (If a splint stretcher combination is used 8. *Two cloth blankets: it will satisfy the requirements of 9. *One rubber blanket or equivalent substitute. both 1 and 2). 10. Two tourniquets; 3. 24 triangular bandages 11. One 1-ounce bottle of aromatic spirits of (15 if a splint-stretcher combination is used). ammonia or 1 dozen ammonia ampules. 4. Eight 4-inch bandage compresses; 12. The necessary complements of arm and leg 5. Eight 2-inch bandage compresses. splints or two each inflatable plastic arm and leg splints. 1. Gauze pads (at least 4 x 4 inches) 2. Two large gauze pads (at least 8 x 10 inches) 3. Box adhesive bandages (band-aids) 4. One package gauze roller bandage at least 2 inches wide 5. Two triangular bandages 6. Wound cleaning agent such as sealed moistened towelettes 7. Scissors 8. At least one blanket 9. Tweezers 10. Adhesive tape 11. Latex gloves 12. Resuscitation equipment such as resuscitation bag, airway, or pocket mask 13. Two elastic wraps 14. Splint 15. Directions for requesting emergency assistance MINERS KR202-620 36R - MSHA - Miners - Refill K202-620 36M - MSHA - Miners - Metal * These items not included in Miners Kit but required for full compliance with MSHA Standard INFLATABLE SPLINTS R505-190 Inflatable Splint - Full Arm R505-226 Inflatable Splint - Hand & Wrist R505-227 Inflatable Splint - Half Arm R505-230 Inflatable Splint - Foot & Ankle R505-231 Inflatable Splint - Half Leg R505-232 Inflatable Splint - Full Leg Complies with: MSHA Standard, 75.1713-7 36 Kit Dimensions: 14”x 9.5”x 3” 16/18 Kit Dimensions: 10”x 7”x 3” LOGGERS KR201-504 16R - Loggers - Refill K201-504 16PW - Loggers - Poly White K201-505 18M - Loggers - Metal K206-040 16NB - Loggers - Green Nylon Bag Contents List on Page 90 Contents List on Page 90 80 79 800.854.7474 Thank You for Your Business! certifiedsafetymfg.com
RkJQdWJsaXNoZXIy MTkwMTc3MQ==